Orbitron Superdevice One
Automotive multi purpose tool for CAN controlled PWM signals, relay switching and voltage measurements
Overview:
- Control, configure and use the device completely over CAN-Bus
- No other Software or Licenses needed, enabling low lifetime cost
- Up to 10A switching current per channel (<80°C)
- Molex MX-150 1,5mm standard, sealed Automotive connector
- Water- and Dust-proof IP67 housing (130x100x40mm)
- Write your own Firmware and use it as „Automotive Arduino“ (option)
Features:
- Generate PWM signals, 1 Hz - 1 kHz, 0-100% duty cycle
- 2 Channel PWM single or inverted-PWM output, f.e. H-bridges
- integrated Fly-off diodes for inductive loads on PWM
- 1 SPDT Relay (Single Pole Double Throw)
- 2 x Voltage measurement inputs, 0-30V DC, 10-bit resolution
- Up to 10A switching current per channel (< 80°C)
- 9-30V DC supply voltage
- Control, configure and use the device completely over CAN-Bus
- CAN v2.0B @: 31.25, 50, 100, 125, 200, 250, 500 or 1000kb/s
- Configurable sending and receiving adress (CAN)
- Configurable default Relay and PWM state at power-on
- Fixed configuration CAN adress: 1FFF FFF F (Hardware Write Protection)
- Build-in CAN-Termination (manual switchable)
- Molex MX-150 1,5mm standard Automotive connector
- Water- and Dust-proof IP67 housing (130x100x40mm)
Please download our our product flyer, complete manual or ask us for more information!
Orbitron makes every effort to insure all statements and information for the products referred to in this document are accurate and reliable. Orbitron can not accept any responsibility for errors, omissions or miss statements, nor can they accept responsibility for any actions taken based on the information demonstrated herein. Orbitron reserves the right to make changes of any kind to the product referred to in this document without prior notice.